Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM

POWER STEERING SYSTEM > DTC CHECK / CLEAR

for Preparation Click here



CHECK DTC (USING THE INTELLIGENT TESTER)
  1. Turn the power switch off.

  2. Connect the intelligent tester to the DLC3.

  3. Turn the power switch on (IG).

  4. Turn the intelligent tester on.

  5. Read the DTCs following the display on the intelligent tester. Enter the following menus: Chassis / EMPS / DTC.

  6. Refer to the Diagnostic Trouble Code Chart for DTC information (Click here).


CHECK DTCs (USING SST CHECK WIRE)


    C248264E05
  1. Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.

    SST
    09843-18040  
    Text in Illustration 
    *1
    DLC3

  2. Turn the power switch on (IG).



  3. F040045E09
  4. Read and write down any DTCs indicated by the EPS warning light on the combination meter. Refer to the chart on the left for examples of a normal code and DTCs 21 and 22.

    HINT:
    1. If the EPS warning light does not blink to display any DTCs set or the normal code, inspect the circuit shown in the table below.
      Trouble Area
      See Page
      EPS warning light circuit
      Click here
    2. If two or more malfunctions are detected simultaneously, DTCs will be displayed in ascending numerical order.

  5. Refer to the Diagnostic Trouble Code Chart for DTC information (Click here).
    Text in Illustration 
    *a
    Normal code
    *b
    Codes 21 and 22


CLEAR DTC (USING THE INTELLIGENT TESTER)
  1. Turn the power switch off.

  2. Connect the intelligent tester to the DLC3.

  3. Turn the power switch on (IG).

  4. Turn the intelligent tester on.

  5. Clear the DTCs following the display on the intelligent tester. Enter the following menus: Chassis / EMPS / DTC / Clear.

  6. Turn the power switch off.

  7. Disconnect the intelligent tester from the DLC3.


CLEAR DTCs (USING SST CHECK WIRE)


    C248264E03
  1. Using SST, connect terminals 12 (TS) and 4 (CG) of the DLC3, and also terminals 13 (TC) and 4 (CG) of the DLC3.

    SST
    09843-18040  

  2. Turn the power switch on (READY).

  3. Disconnect and reconnect terminal 13 (TC) of the DLC3 4 times or more within 8 seconds.

  4. Check that the EPS warning light blinks a code to indicate normality.

  5. Turn the power switch off.

  6. Remove SST from the DLC3.

Text in Illustration 
*1
DLC3