Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM

POWER STEERING SYSTEM > DIAGNOSTIC TROUBLE CODE CHART

for Preparation Click here


HINT:
If any DTCs are displayed during the DTC check, inspect the circuit listed for those DTCs. For details of each DTC, refer to the page indicated in the DTC chart.


Power Steering System 
DTC Code
Detection Item
Return-to-normal Condition
EPS Warning Light
See page
C1511/11
Torque Sensor 1 Malfunction
Power switch on (IG) again
*1
Click here
C1512/11
Torque Sensor 2 Malfunction
Power switch on (IG) again
*1
Click here
C1513/11
Torque Sensor Deviation Excessive
Power switch on (IG) again
*1
Click here
C1514/11
Torque Sensor Power Supply Voltage Malfunction
Power switch on (IG) again
*1
Click here
C1521/25
Short in Motor Circuit
Power switch on (IG) again
*1
Click here
C1524/24
Motor Circuit Malfunction
Power switch on (IG) again
*1
Click here
C1528/12
Motor Rotation Angle Sensor Malfunction
Power switch on (IG) again
*1
Click here
C1531/25
ECU Malfunction
Power switch on (IG) again
*1
Click here
C1532/25
ECU Malfunction
Power switch on (IG) again
*1
Click here
C1533/25
Temperature Sensor Circuit is Low or High
After normal judgment
*2
Click here
C1534/25
EEPROM Malfunction
After normal judgment
*3
Click here
C1541/13
Vehicle Speed Signal
Power switch on (IG) again
*1
Click here
C1551/25
IG Power Supply Voltage Malfunction
Power switch on (IG) again or after normal confirmation
*1
Click here
C1552/22
PIG Power Supply Voltage Malfunction
Power switch on (IG) again or after normal confirmation
*1
Click here
C1554/23
Power Supply Relay Failure
Power switch on (IG) again
*1
Click here
C1555/25
Motor Relay Welding Failure
Power switch on (IG) again
*1
Click here
C1581/26
Assist Map Number Un-Writing
Assist map written
*1
Click here
C1582/26
Assist Map Number Mismatch
Power switch on (IG) again
*2
Click here
U0129/42
Lost Communication with Brake System Control Module
After normal confirmation
*1
Click here
U0293/41
Lost Communication with Hybrid Control Module
After normal confirmation
*1
Click here

HINT:
  1. *1: Warning light comes on
  2. *2: Warning light turns off
  3. *3: Set with default value and it continues the control. In this case, the warning light illuminates.