Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM

POWER STEERING SYSTEM > CALIBRATION

for Preparation Click here



ASSIST MAP WRITING (USING THE INTELLIGENT TESTER)
  1. Turn the power switch off.

  2. Connect the intelligent tester to the DLC3.

  3. Turn the power switch on (IG).

  4. Turn the intelligent tester on.

  5. Enter the following menus: Chassis / EMPS / Utility / Signal Check.

    HINT:
    1. Follow the instructions on the intelligent tester to perform Signal Check.
    2. With DTC C1581/26 output, performing Signal Check will cause the power steering ECU assembly to enter Test Mode and the assist map will be written automatically.

  6. Wait for at least 5 seconds.

  7. Check for DTCs (Click here).

    HINT:
    After writing the assist map, if DTC C1581/26 is output, perform the troubleshooting procedure for DTC C1581/26 (Click here).


ASSIST MAP WRITING (USING SST CHECK WIRE)


    C248264E07
  1. Turn the power switch off

  2. Using SST, connect terminals 12 (TS) and 4 (CG) of the DLC3.

    SST
    09843-18040  

    NOTICE:
    Connect the terminals correctly to avoid a malfunction.

  3. Turn the power switch on (IG).

  4. Wait for 5 seconds or more.

  5. Check for DTCs (Click here).

    HINT:
    After writing the assist map, if DTC C1581/26 is output, perform the troubleshooting procedure for DTC C1581/26 (Click here).

Text in Illustration 
*1
DLC3