Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM

DTC    36    ABS Control System Malfunction

DTC    43    ABS Control System Malfunction

for Preparation Click here


DESCRIPTION

These DTCs are stored if the VSC and/or electronically controlled brake system detects a malfunction in the ABS control system.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
36
-
Malfunction in the ABS control system.
ABS control system
43
-
Malfunction in the ABS control system.
ABS control system

INSPECTION PROCEDURE

NOTICE:
When replacing the skid control ECU (brake booster with master cylinder assembly), perform initialization and calibration of the linear solenoid valve (Click here).

1.CHECK ABS CONTROL SYSTEM
  1. Clear the DTCs (Click here).

  1. Turn the power switch on (READY).

  1. Drive the vehicle at a speed of approximately 40 km/h (25 mph) or more for 60 seconds or more.

  1. Check if an ABS control system DTC is output (Click here).

    Result:

    Result
    Proceed to
    ABS control system DTC is not output.
    A
    ABS control system DTC is output.
    B



B
REPAIR CIRCUITS INDICATED BY OUTPUT DTCS (Click here)
A


2.RECONFIRM DTC
  1. Turn the power switch off.

  1. Clear the DTCs (Click here).

  1. Turn the power switch on (READY).

  1. Drive the vehicle at a speed of approximately 40 km/h (25 mph) or more for 60 seconds or more.

  1. Check if the same DTC is output (Click here).

    Result:

    Result
    Proceed to
    DTCs 36 and 43 are not output.
    A
    DTCs 36 and/or 43 are output (for LHD).
    B
    DTCs 36 and/or 43 are output (for RHD).
    C



B
REPLACE BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY (Click here)

C
REPLACE BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY (Click here)
A

CHECK FOR INTERMITTENT PROBLEMS (Click here)