Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM

AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM > PROBLEM SYMPTOMS TABLE

for Preparation Click here


Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

Automatic Headlight Beam Level Control 
Symptom
Suspected Area
See page
"Check Headlight System" is displayed on the multi-information display (headlight leveling control is normal)
Headlight beam level warning circuit
Click here
Headlight leveling ECU assembly
Click here
Headlight beam level control does not operate.
Check the FAIL-SAFE function
Click here
Check DTCs
Click here
Headlight leveling ECU power source circuit
Click here
Headlight signal circuit
Click here
Headlight beam level control actuator circuit
Click here
Speed signal circuit
Click here
Headlight leveling ECU assembly
Click here
DTC information cannot be detected.
Diagnosis circuit
Click here
Headlight leveling ECU assembly
Click here
Initialization cannot be performed.
Check DTCs
Click here
LVL terminal circuit
Click here
Headlight leveling ECU assembly
Click here

NOTICE:
  1. Initialize the headlight leveling ECU assembly after the vehicle height changes due to replacement of suspension components or after performing operations such as removal and reinstallation or replacement of the rear height control sensor sub-assembly.
  2. When the headlight leveling ECU assembly is replaced, initialization is also necessary.