DTC P0657 Actuator Supply Voltage Circuit / Open |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0657 | A throttle actuator power supply error (1 trip detection logic). | ECM |
| Required Sensors/Components | ECM |
| Frequency of Operation | Once per driving cycle |
| GTS Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.READ OUTPUT DTC (DTC P0657) |
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Clear the DTCs (Click here).
Turn the power switch off.
Turn the GTS off.
Disconnect the GTS.
Disconnect the cable from the negative (-) auxiliary battery terminal and wait for 1 minute.
Connect the cable to the negative (-) auxiliary battery terminal.
Turn the power switch on (IG).
Wait 10 seconds or more.
Turn the power switch off.
Wait 15 seconds or more.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Wait 5 seconds or more.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| DTCs are not output | A |
| DTC P0657 is output | B |
|
| ||||
| A | ||
| ||