BRAKE PEDAL (for LHD) > INSTALLATION |
| 1. INSTALL BRAKE PEDAL SUPPORT ASSEMBLY |
Install the brake pedal support assembly with the 4 nuts.
Engage the 3 clamps to install the wire harness to the brake pedal support assembly.
Engage the clamp.
| 2. INSTALL BRAKE PEDAL RETURN SPRING |
![]() |
Install the brake pedal return spring to the brake pedal support assembly.
| 3. INSTALL PUSH ROD PIN |
![]() |
Apply lithium soap base glycol grease to the push rod pin.
![]() | Lithium Soap Base Glycol Grease |
Connect the brake master cylinder push rod clevis to the brake pedal support assembly with the push rod pin, and install a new clip as shown in the illustration.
| 4. INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER |
| 5. INSTALL STOP LIGHT SWITCH ASSEMBLY |
![]() |
Insert the stop light switch assembly until the threaded sleeve hits the pedal.
![]() |
Make a quarter turn clockwise to install the stop light switch assembly.
Connect the connector.
Check the protrusion of the plunger.
| Area | Measurement |
| a | 1.5 to 2.5 mm (0.0591 to 0.0984 in.) |
| 6. INSTALL HEADLIGHT LEVELING ECU ASSEMBLY |
Engage the 2 guides to temporarily install the headlight leveling ECU assembly.
Install the headlight leveling ECU assembly with the bolt.
Engage the clamp.
Connect the connector.
| 7. INSTALL BRAKE PEDAL STROKE SENSOR ASSEMBLY |
When installing a new brake pedal stroke sensor assembly:
![]() |
Install a new brake pedal stroke sensor assembly to the brake pedal support assembly with the 2 bolts.
| *1 | Brake Pedal Stroke Sensor Assembly Lever |
| *a | Brake Pedal Groove |
Firmly depress the brake pedal and break the brake pedal stroke sensor assembly lever set pin.
Remove the broken lever set pin.
Connect the connector to the brake pedal stroke sensor assembly.
When reusing the brake pedal stroke sensor assembly:
![]() |
Temporarily install the brake pedal stroke sensor assembly to the brake pedal support assembly with the 2 bolts.
| *1 | Brake Pedal Stroke Sensor Assembly Lever |
| *a | Brake Pedal Groove |
Connect the connector to the brake pedal stroke sensor assembly.
| 8. INSTALL INSTRUMENT PANEL REINFORCEMENT ASSEMBLY WITH AIR CONDITIONING UNIT |
| 9. INSPECT AND ADJUST BRAKE PEDAL |