Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING ECU

POWER STEERING ECU > REMOVAL

for Preparation Click here



1. REMOVE STEERING COLUMN ASSEMBLY
(Click here)


2. REMOVE STEERING LOCK ACTUATOR ASSEMBLY
  1. Using a center punch, mark the center of the 2 tapered-head bolts.

  1. Using a 3 to 4 mm (0.118 to 0.157 in.) diameter drill bit, drill a hole in each tapered-head bolt.



    C236195
  1. Using a screw extractor, remove each tapered-head bolt, and then remove the steering lock actuator assembly from the steering column assembly.



3. REMOVE POWER STEERING ECU PROTECTOR


    C241687
  1. Disengage the 2 claws to remove the power steering ECU protector from the power steering ECU with motor assembly.



4. DISCONNECT ECU WIRE SUB-ASSEMBLY


    C239370
  1. Disconnect the 2 connectors from the power steering ECU assembly.



5. REMOVE POWER STEERING ECU WITH MOTOR ASSEMBLY


    C236194E01
  1. Secure the steering column assembly in a vice using aluminum plates as shown in the illustration.
    Text in Illustration 
    *1
    Aluminum Plate
    *2
    Wooden Block

    NOTICE:
    1. Do not overtighten the vice, as the steering column assembly may become deformed.
    2. Support the steering column assembly with a wooden block or similar item to ensure that it does not fall.



    C236197
  1. Disconnect the 2 connectors from the power steering ECU with motor assembly.



    C236198
  1. Remove the 2 bolts and power steering ECU with motor assembly from the electric power steering column sub-assembly.



    C239326
  1. Remove the O-ring from the power steering ECU with motor assembly.



6. REMOVE POWER STEERING ECU ASSEMBLY


    C236199
  1. Disengage the 4 claws to remove the protector.



    C239324
  1. Remove the 3 bolts.



    C239325
  1. Remove the 2 bolts to remove the power steering ECU assembly from the power steering motor assembly.