DTC P0705-758 Transmission Range Sensor Circuit |
| DTC No. | INF Code | DTC Detection Condition | Trouble Area |
| P0705 | 758 | Shifting malfunction (open circuit in MJ) |
|
| 1.CHECK DTC OUTPUT (HYBRID CONTROL) |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Enter the following menus: Powertrain / Hybrid Control / DTC.
Check if DTCs are output.
| Result | Proceed to |
| P0705-758 only is output. | A |
| P0705-757 is also output. | B |
Turn the power switch off.
|
| ||||
| A | |
| 2.CHECK SHIFT LEVER POSITION SENSOR |
Turn the power switch on (IG).
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A39-16 (MJ) - Body ground | Power switch on (IG) Shift lever in P, R, N, D, or B | 11 to 14 V |
| *a | Component with harness connected (Power Management Control ECU) |
Turn the power switch off.
|
| ||||
| OK | |
| 3.CHECK FOR INTERMITTENT PROBLEMS |
|
| ||||
| OK | ||
| ||
| 4.CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT) |
Disconnect the shift lever position sensor connector.
Turn the power switch on (IG).
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| E11-8 (+B) - Body ground | Power switch on (IG) | 11 to 14 V |
| *a | Front view of wire harness connector (to Shift Lever Position Sensor) |
Turn the power switch off.
Connect the shift lever position sensor connector.
|
| ||||
| OK | |
| 5.INSPECT SHIFT LEVER POSITION SENSOR |
Disconnect the shift lever position sensor connector.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E11-8 (+B) - E11-5 (MJ) | Shift lever in P, R, N, D, or B | Below 1 Ω |
| *a | Component without harness connected (Shift Lever Position Sensor) |
Connect the shift lever position sensor connector.
|
| ||||
| OK | ||
| ||