Home › Vehicle Exterior › LIGHTING (EXT) › REAR COMBINATION LIGHT ASSEMBLY

REAR COMBINATION LIGHT ASSEMBLY > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure described below is for the LH side.



1. INSTALL REAR COMBINATION LIGHT ASSEMBLY
  1. Install the rear combination light assembly with the 4 nuts.

    Torque:
    4.1 N*m{ 42 kgf*cm , 36 in.*lbf }

  1. Engage the clamp.

  1. Connect each connector.



2. INSTALL LUGGAGE COMPARTMENT INNER TRIM COVER
  1. Install the 3 clips.

  1. Engage the fastener and install the luggage compartment inner trim cover LH.



3. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK


    B288531E01
  1. Engage the pin to install the No. 1 luggage compartment trim hook.
    Text in Illustration 
    *1
    Pin



4. INSTALL LUGGAGE COMPARTMENT FRONT TRIM COVER
  1. Engage the 2 claws.

  1. Engage the 8 fasteners and install the luggage compartment front trim cover.



5. INSTALL REAR FLOOR FINISH PLATE


    B287056
  1. Engage the 4 clips and install the rear floor finish plate.

  1. Install the 5 clips.



6. INSTALL BAGGAGE HOLDER NET
  1. Install the baggage holder net.



7. INSTALL LUGGAGE COMPARTMENT FLOOR MAT
  1. Install the luggage compartment floor mat.



8. INSTALL REAR BUMPER ASSEMBLY
(Click here)