Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM

DTC    C1442/44    Invalid Data Received from Acceleration Sensor

DTC    C1443/34    Invalid Data Received from Yaw Rate Sensor

for Preparation Click here


DESCRIPTION

The skid control ECU receives signals from the yaw rate and acceleration sensor (airbag sensor assembly) via the CAN communication system.
The airbag sensor assembly has a built-in yaw rate and acceleration sensor and detects the vehicle condition.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
C1442/44
572
With terminal IG1 voltage between 9.5 and 17.4 V, an invalid data signal is received from the acceleration sensor for 10 seconds or more.
Yaw rate and acceleration sensor (Airbag sensor assembly)
C1443/34
715
With terminal IG1 voltage between 9.5 and 17.4 V, an invalid data signal is received from the yaw rate sensor for 10 seconds or more.
Yaw rate and acceleration sensor (Airbag sensor assembly)

INSPECTION PROCEDURE

NOTICE:
When replacing the yaw rate and acceleration sensor (airbag sensor assembly), perform zero point calibration (Click here).

1.CHECK DTC
  1. Clear the DTCs (Click here).

  1. Check if the same DTC is output (Click here).

    Result:

    Result
    Proceed to
    DTCs C1442/44 and C1443/34 are not output.
    A
    DTCs C1442/44 and/or C1443/34 are output.
    B



B
REPLACE AIRBAG SENSOR ASSEMBLY (Click here)
A

CHECK FOR INTERMITTENT PROBLEMS (Click here)