OIL PRESSURE SWITCH > INSTALLATION |
| 1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY |
![]() |
Apply adhesive to 2 or 3 threads of the oil pressure switch.
| *1 | Adhesive |
Using a 24 mm deep socket wrench, install the oil pressure switch.
Connect the connector.
| 2. INSPECT FOR OIL LEAK |
| 3. INSPECT ENGINE OIL LEVEL |
Put the engine in inspection mode (Click here).
Warm up and stop the engine, and then wait 5 minutes.
Check that the oil level is between the low level mark and full level mark on the engine oil level dipstick.
If the level is low, check for leakage and add oil up to the full level mark.