Home › Engine / Hybrid System › 2AR-FXE LUBRICATION › LUBRICATION SYSTEM

LUBRICATION SYSTEM > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT ENGINE OIL LEVEL
  1. Put the engine in inspection mode (Click here).

  1. Warm up and stop the engine, and then wait 5 minutes.

  1. Check that the oil level is between the low level mark and full level mark on the engine oil level dipstick.
    If the level is low, check for leakage and add oil up to the full level mark.

    NOTICE:
    Do not fill the engine with oil to above the full level mark.



2. INSPECT ENGINE OIL QUALITY
  1. Check the oil for deterioration, water contamination, discoloration or thinning. If the quality is visibly poor, replace the oil and filter.



3. INSPECT OIL PRESSURE
  1. Remove the oil pressure switch assembly (Click here).



    A209392E02
  1. Install an oil pressure gauge with the adapter.
    Text in Illustration 
    *1
    Oil Pressure Gauge

  1. Put the engine in inspection mode (Click here).

  1. Warm up the engine.

  1. Measure the oil pressure.

    Standard Oil Pressure:
    Condition
    Engine Oil Temperature
    Specified Condition
    1000 rpm
    80°C (176°F)
    145 kPa (1.5 kgf/cm2, 21 psi)
    2500 rpm
    340 kPa (3.5 kgf/cm2, 49 psi)

  1. Remove the oil pressure gauge with the adapter.

  1. Install the oil pressure switch assembly (Click here).