Home › Engine / Hybrid System › 2AR-FXE LUBRICATION › OIL PUMP

OIL PUMP > REMOVAL

for Preparation Click here


NOTICE:
Do not remove the oil pump or oil pump relief valve from the timing chain cover sub-assembly.



1. REMOVE ENGINE AND TRANSAXLE
(Click here)


2. REMOVE ENGINE WIRE


3. REMOVE IGNITION COIL ASSEMBLY


    A256134
  1. Disconnect the 4 ignition coil assembly connectors.



    A207955
  1. Remove the 4 bolts and 4 ignition coil assemblies.



4. REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY


    A195876
  1. Remove the 16 bolts, 3 seal washers, cylinder head cover and cylinder head cover gasket.



    A259133
  1. Remove the 2 gaskets from the camshaft bearing caps.



5. REMOVE CRANKSHAFT POSITION SENSOR


A256136
  1. Disconnect the sensor connector.

  1. Remove the bolt and sensor.



6. REMOVE CRANKSHAFT PULLEY


    A195873E16
  1. Using SST, hold the crankshaft pulley and loosen the pulley bolt. Further loosen the bolt until 2 or 3 threads are screwed into the crankshaft.
    Text in Illustration 
    *a
    Hold
    *b
    Turn

    SST
    09213-54015  
    09330-00021  

    HINT:
    SST (Crankshaft pulley holding tool) Fixing bolt part No. : 91551-80650 (2 pcs)



    A195874E04
  1. Using SST and the pulley bolt, remove the crankshaft pulley.
    Text in Illustration 
    *1
    Pulley Bolt
    *a
    Hold
    *b
    Turn

    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05011)

    HINT:
    Apply a lubricant to the threads and end of SST.



7. REMOVE ENGINE MOUNTING BRACKET RH


    A259135
  1. Remove the 5 bolts and engine mounting bracket RH.



8. REMOVE TIMING CHAIN COVER SUB-ASSEMBLY


    A235204
  1. Remove the 17 bolts and 2 nuts.



    A196856E03
  1. Remove the timing chain cover by prying between the timing chain cover and cylinder head, camshaft housing, cylinder block and stiffening crankcase with a screwdriver as shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape

    NOTICE:
    Be careful not to damage the contact surfaces of the cylinder head, camshaft housing, cylinder block, stiffening crankcase or chain cover.

    HINT:
    Tape the screwdriver tip before use.



    A196858
  1. Remove the 3 gaskets from the stiffening crankcase.



9. REMOVE TIMING CHAIN COVER OIL SEAL


    A210537E03
  1. Using a screwdriver and wooden block, pry out the oil seal.
    Text in Illustration 
    *1
    Protective Tape
    *2
    Wooden Block

    NOTICE:
    Do not damage the surface of the oil seal press fit hole.

    HINT:
    Tape the screwdriver tip before use.