DTC B278C Lost Communication with Power Source Control |
| DTC No. | DTC Detection Condition | Trouble Area |
| B278C | No communication between the certification ECU (smart key ECU assembly) and power management control ECU for 10 seconds or more. |
|

| 1.CHECK HARNESS AND CONNECTOR (POWER MANAGEMENT CONTROL ECU - AUXILIARY BATTERY AND BODY GROUND) |
Disconnect the I3 and I4 power management control ECU connectors.
Measure the resistance and voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I3-6 (E1) - Body ground | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| I3-1 (AM22) - Body ground | Power switch off | 11 to 14 V |
| I4-7 (AM21) - Body ground | Power switch off | 11 to 14 V |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - POWER MANAGEMENT CONTROL ECU) |
Disconnect the I87 certification ECU (smart key ECU assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I87-12 (LIN) - I4-11 (LIN2) | Always | Below 1 Ω |
| I87-12 (LIN) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.REPLACE POWER MANAGEMENT CONTROL ECU |
Replace the power management control ECU (Click here).
| NEXT | |
| 4.CHECK DTC OUTPUT |
Clear the DTC (Click here).
Recheck for DTCs.
|
| ||||
| OK | ||
| ||