Home › Engine / Hybrid System › 2AR-FXE EMISSION CONTROL › EGR COOLER

EGR COOLER > INSTALLATION

for Preparation Click here



1. INSTALL EGR COOLER ASSEMBLY
  1. Install 2 new gaskets to the EGR cooler assembly.



    A258463E03
  1. Temporarily install the EGR cooler assembly with the bolt (A) and nut (A).
    Text in Illustration 
    *a
    Bolt A
    *b
    Nut A
    *c
    Bolt B
    *d
    Nut B
    *e
    Bolt C

  1. Using an E8 "TORX" socket wrench, install the stud bolt to the EGR cooler assembly.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }

  1. Temporarily install the No. 1 water by-pass pipe with the bolt (B) and nut (B).

  1. Temporarily install the No. 1 EGR pipe with the 2 bolts (C).

  1. Tighten the 4 bolts and 2 nuts.

    Torque:
    Bolt (A), Bolt (B), Nut (A) and Nut (B):
    21 N*m{ 214 kgf*cm , 15 ft.*lbf }
    Bolt (C):
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

    NOTICE:
    Make sure that all installation surfaces of the EGR cooler assembly are in even contact when tightening the bolts and nuts.

  1. Connect the water by-pass hose to the EGR cooler assembly and slide the clip to secure it.



2. INSTALL EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY (TWC: Front Catalyst)
(Click here)