EGR COOLER > REMOVAL |
| 1. REMOVE EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY (TWC: Front Catalyst) |
| 2. REMOVE EGR COOLER ASSEMBLY |
![]() |
Slide the clip and disconnect the water by-pass hose from the EGR cooler assembly.
![]() |
Remove the bolt and nut and separate the No. 1 EGR pipe.
Using an E8 "TORX" socket wrench, remove the stud bolt from the EGR cooler assembly.
![]() |
Remove the 2 bolts and separate the No. 1 water by-pass pipe.
![]() |
Remove the bolt, nut and EGR cooler assembly from the cylinder block.
![]() | Bolt |
![]() | Nut |
Remove the 2 gaskets from the EGR cooler assembly.