Home › Drivetrain › P314 HYBRID TRANSMISSION / TRANSAXLE › MOTOR WATER JACKET COVER ASSEMBLY

MOTOR WATER JACKET COVER ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL NO. 1 MOTOR WATER JACKET COVER ASSEMBLY
  1. Remove any remaining seal packing from the transaxle housing installation surface and bolt holes.

    NOTICE:
    1. Clean and degrease the installation surface and bolt holes.
    2. Do not allow any remaining seal packing to enter the coolant path when cleaning.



    C245951
  1. Apply seal packing in a continuous line as shown in the illustration.

    Seal packing:
    Toyota Genuine Seal Packing 1282B, Three Bond 1282B or equivalent

    Standard seal diameter:
    1.5 mm (0.059 in.) or more.

    NOTICE:
    Remove any oil from the contact surface.

  1. Install a new No. 1 motor water jacket cover assembly to the hybrid vehicle transaxle with 8 new bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

    NOTICE:
    1. Install the motor water jacket cover assembly within 3 minutes and tighten the bolts within 10 minutes after applying seal packing.
    2. Do not add coolant within 2 hours after installing the motor water jacket cover assembly.
    3. Do not start the engine for at least 2 hours after installing the motor water jacket cover assembly.



2. INSTALL AUTOMATIC TRANSMISSION CASE COVER
  1. Install the automatic transmission case cover to the hybrid vehicle transaxle with the 2 bolts and clip.

    Torque:
    12 N*m{ 120 kgf*cm , 9 ft.*lbf }



3. INSTALL NO. 1 TRANSMISSION CONTROL CABLE BRACKET


4. INSTALL FRONT ENGINE MOUNTING BRACKET


5. INSTALL NO. 2 MOTOR WATER JACKET COVER ASSEMBLY
  1. Remove any remaining seal packing from the transaxle housing installation surface and bolt holes.

    NOTICE:
    1. Clean and degrease the installation surface and bolt holes.
    2. Do not allow any remaining seal packing to enter the coolant path when cleaning.



    C245952
  1. Apply seal packing in a continuous line as shown in the illustration.

    Seal packing:
    Toyota Genuine Seal Packing 1282B, Three Bond 1282B or equivalent

    Standard seal diameter:
    1.5 mm (0.059 in.) or more.

    NOTICE:
    Remove any oil from the contact surface.

  1. Install a new No. 2 motor water jacket cover assembly to the hybrid vehicle transaxle with 5 new bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

    NOTICE:
    1. Install the motor water jacket cover assembly within 3 minutes and tighten the bolts within 10 minutes after applying seal packing.
    2. Do not add coolant within 2 hours after installing the motor water jacket cover assembly.
    3. Do not start the engine for at least 2 hours after installing the motor water jacket cover assembly.



6. INSTALL HYBRID VEHICLE TRANSAXLE ASSEMBLY
(Click here)