Home › Brake › BRAKE (REAR) › REAR BRAKE FLEXIBLE HOSE

REAR BRAKE FLEXIBLE HOSE > INSTALLATION

for Preparation Click here


NOTICE:
  1. Because the left and right rear flexible hoses are not interchangeable, verify the part number when installing the flexible hoses.
  2. If the hoses are to be reused, connect them after checking the identification marks placed when each hose was disconnected.

HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The following procedure is for the LH side.



1. INSTALL REAR FLEXIBLE HOSE


    C243121E01
  1. Connect the rear flexible hose to the rear disc brake cylinder assembly with a new union bolt and a new gasket.

    Torque:
    33 N*m{ 340 kgf*cm , 25 ft.*lbf }

    Text in Illustration 
    *a
    Lock Hole

    NOTICE:
    Install the flexible hose lock securely into the lock hole in the disc brake cylinder.



    C283878E01
  1. Install the rear flexible hose with a bolt.
    Text in Illustration 
    *1
    Brake Line
    *2
    Clip
    *3
    Bolt
    *a
    Torque Wrench Fulcrum Length

    Torque:
    19 N*m{ 192 kgf*cm , 14 ft.*lbf }

  1. Install a new clip.

    NOTICE:
    Install the clip as far as it will go.

  1. Using a union nut wrench, connect the brake line to the rear flexible hose while holding the rear flexible hose with a wrench.

    Torque:
    Specified Tightening Torque:
    15 N*m{ 155 kgf*cm , 11 ft.*lbf }

    NOTICE:
    1. Do not kink or damage the brake line.
    2. Do not allow any foreign matter such as dirt or dust to enter the brake line from the connecting points.

    HINT:
    1. Calculate the torque wrench reading when changing the fulcrum length for the torque wrench (Click here).
    2. When using a union nut wrench (fulcrum length of 22 mm (0.866 in.)) + torque wrench (fulcrum length of 250 mm (9.84 in.)):
      14 N*m (142 kgf*cm, 10 ft.*lbf)



2. BLEED BRAKE LINE
(Click here)


3. INSTALL REAR WHEEL

Torque:
103 N*m{ 1049 kgf*cm , 76 ft.*lbf }