Home › Engine / Hybrid System ยท 6AR-FSE › ENGINE CONTROL › SFI SYSTEM

SFI SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
*: Use the GTS.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS

      NEXT


      3.CONNECT GTS TO DLC3*

        HINT:
        If the display indicates a communication malfunction, inspect the DLC3.
        If any CAN communication system DTCs are output, perform troubleshooting for the CAN communication system first.


      NEXT


      4.CHECK DTC AND FREEZE FRAME DATA*
      1. Check for DTCs (Click here).

      2. Check for freeze frame data (Click here).

      3. HINT:
        Record or print DTCs and freeze frame data if necessary.


      NEXT


      5.CLEAR DTC AND FREEZE FRAME DATA*
      1. Clear the DTCs and freeze frame data (Click here).


      NEXT


      6.CONDUCT VISUAL INSPECTION

        NEXT


        7.SELECT CHECK MODE DIAGNOSIS*
        1. Switch the ECM from normal mode to check mode (Click here).


        NEXT


        8.CONFIRM PROBLEM SYMPTOMS
        1. Confirm problem symptoms.

          HINT:
          If the engine does not start, first perform the "Check DTC" procedure and "Conduct Basic Inspection" procedure below.


          Result 
          Result
          Proceed to
          Malfunction does not occur
          A
          Malfunction occurs
          B



        B.
        GO TO STEP 10
        A


        9.SIMULATE SYMPTOMS

          HINT:
          Refer to Symptom Simulation (Click here).


        NEXT


        10.CHECK DTC*
        1. Check for DTCs (Click here).

          Result 
          Result
          Proceed to
          DTCs are output
          A
          DTCs are not output
          B



        B.
        GO TO STEP 12
        A


        11.REFER TO DTC CHART

          HINT:
          Refer to Diagnostic Trouble Code Chart (Click here).


        NEXT


        12.CONDUCT BASIC INSPECTION
        1. Conduct basic inspection (Click here).

          Result 
          Result
          Proceed to
          Malfunctioning parts not confirmed
          A
          Malfunctioning parts confirmed
          B



        B.
        GO TO STEP 17
        A


        13.REFER TO PROBLEM SYMPTOMS TABLE

          HINT:
          Refer to Problem Symptoms Table (Click here).


          Result 
          Result
          Proceed to
          Malfunctioning circuit confirmed
          A
          Malfunctioning parts confirmed
          B


        B.
        GO TO STEP 17
        A


        14.CHECK ECM POWER SOURCE CIRCUIT
        1. Check the ECM power source circuit (Click here).


        NEXT


        15.CONDUCT CIRCUIT INSPECTION

          Result 
          Result
          Proceed to
          Malfunction not confirmed
          A
          Malfunction confirmed
          B


        B.
        GO TO STEP 18
        A


        16.CHECK FOR INTERMITTENT PROBLEMS
        1. Check for intermittent problems (Click here).


        NEXT


        17.CONDUCT PARTS INSPECTION

          NEXT


          18.IDENTIFY PROBLEM

            NEXT


            19.ADJUST AND/OR REPAIR

              NEXT


              20.CONDUCT CONFIRMATION TEST

                NEXT

                END