Home › Engine / Hybrid System ยท 2AR-FE › ENGINE CONTROL › SFI SYSTEM

SFI SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
*: Use the intelligent tester.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS

      NEXT


      3.CONNECT INTELLIGENT TESTER TO DLC3*

        HINT:
        If the display indicates a communication fault in the intelligent tester, inspect the DLC3.
        When any CAN communication system DTCs are output, perform troubleshooting on the CAN communication system first.


      NEXT


      4.CHECK DTC AND FREEZE FRAME DATA*
      1. Check for DTCs (Click here) and freeze frame data (Click here).

        HINT:
        Record or print DTCs and freeze frame data if necessary.


      NEXT


      5.CLEAR DTC AND FREEZE FRAME DATA*
      1. Clear the DTCs and freeze frame data (Click here).


      NEXT


      6.CONDUCT VISUAL INSPECTION

        NEXT


        7.SELECT CHECK MODE DIAGNOSIS*
        1. Switch the ECM from normal mode to check mode.

          HINT:
          Refer to Check Mode Procedure (Click here).


        NEXT


        8.CONFIRM PROBLEM SYMPTOMS
        1. Confirm problem symptoms.

          HINT:
          If the engine does not start, first perform the "Check DTC" procedure and "Conduct Basic Inspection" procedure below.


          Result 
          Result
          Proceed to
          Malfunction does not occur
          A
          Malfunction occurs
          B



        B.
        GO TO STEP 10
        A


        9.SIMULATE SYMPTOMS

          HINT:
          Refer to Symptom Simulation (Click here).


        NEXT


        10.CHECK DTC*
        1. Check for DTCs.

          HINT:
          Refer to DTC Check / Clear (Click here).


          Result 
          Result
          Proceed to
          Trouble code output
          A
          Trouble code is not output
          B



        B.
        GO TO STEP 12
        A


        11.REFER TO DTC CHART

          HINT:
          Refer to Diagnostic Trouble Code Chart (Click here).


        NEXT


        12.CONDUCT BASIC INSPECTION
        1. Conduct basic inspection.

          HINT:
          Refer to Basic Inspection (Click here).


          Result 
          Result
          Proceed to
          Malfunctioning parts not confirmed
          A
          Malfunctioning parts confirmed
          B



        B.
        GO TO STEP 17
        A


        13.REFER TO PROBLEM SYMPTOMS TABLE

          HINT:
          Refer to Problem Symptoms Table (Click here).


          Result 
          Result
          Proceed to
          Malfunctioning circuit confirmed
          A
          Malfunctioning parts confirmed
          B


        B.
        GO TO STEP 17
        A


        14.CHECK ECM POWER SOURCE CIRCUIT
        1. Check the ECM power source circuit.

          HINT:
          Refer to ECM Power Source Circuit (Click here).


        NEXT


        15.CONDUCT CIRCUIT INSPECTION

          Result 
          Result
          Proceed to
          Malfunction not confirmed
          A
          Malfunction confirmed
          B


        B.
        GO TO STEP 18
        A


        16.CHECK FOR INTERMITTENT PROBLEMS
        1. Check for intermittent problems.

          HINT:
          Refer to Check for Intermittent Problems (Click here).


        NEXT


        17.CONDUCT PARTS INSPECTION

          NEXT


          18.IDENTIFY PROBLEM

            NEXT


            19.ADJUST AND/OR REPAIR

              NEXT


              20.CONDUCT CONFIRMATION TEST

                NEXT

                END