Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › STEERING ANGLE SENSOR

STEERING ANGLE SENSOR > REMOVAL

for Preparation Click here


NOTICE:
If both the spiral cable sub-assembly and the steering sensor are malfunctioning, replace them with a new spiral cable with sensor sub-assembly.



1. REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
for TMC, TMMR Made: (Click here)
for TMMK Made: (Click here)


2. REMOVE STEERING SENSOR


    C238435
  1. Disengage the 6 claws and 2 pins, and remove the steering sensor from the spiral cable sub-assembly.

    NOTICE:
    Do not damage the claws and pins of the spiral cable sub-assembly.