DTC P0335 Crankshaft Position Sensor "A" Circuit |
DTC P0339 Crankshaft Position Sensor "A" Circuit Intermittent |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0335 | One of the following conditions is met (1 trip detection logic):
|
|
| P0339 | All of the following conditions are met (1 trip detection logic): (a) The engine speed is 1000 rpm or higher. (b) No crankshaft position sensor signal for 0.05 seconds or more. (c) 3 seconds or more have elapsed since the starter signal switched from on to off. |
|
![]() |
| ECM Terminal Name | Between NE+ and NE- |
| Tester Range | 5 V/DIV., 20 ms./DIV. |
| Condition | Idling |
| Required Sensors/Components (Main) | Crankshaft position sensor |
| Required Sensors/Components (Related) | Camshaft position sensor |
| Frequency of Operation | Continuous |
| Crankshaft position sensor |
|
| Tester Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|

| 1.READ VALUE USING INTELLIGENT TESTER (ENGINE SPEED) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / Engine Speed.
Start the engine.
Read the values displayed on the tester while the engine is running.
|
| ||||
| OK | ||
| ||
| 2.INSPECT CRANKSHAFT POSITION SENSOR (RESISTANCE) |
Inspect the crankshaft position sensor (Click here).
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (CRANKSHAFT POSITION SENSOR - ECM) |
Disconnect the crankshaft position sensor connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E72-1 - E26-76 (NE+) | Always | Below 1 Ω |
| E72-2 - E26-109 (NE-) | Always | Below 1 Ω |
| E72-1 or E26-76 (NE+) - Body ground | Always | 10 kΩ or higher |
| E72-2 or E26-109 (NE-) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.CHECK SENSOR INSTALLATION (CRANKSHAFT POSITION SENSOR) |
![]() |
Check the crankshaft position sensor installation.
|
| ||||
| OK | |
| 5.INSPECT CRANKSHAFT (TEETH OF CRANK ANGLE SENSOR PLATE) |
Inspect the teeth of the crank angle sensor plate.
|
| ||||
| OK | ||
| ||