DTC B278A Short to GND in Immobiliser System Power Source Circuit |
| DTC Code | DTC Detection Condition | Trouble Area | DTC Output Confirmation Operation |
| B278A | A short to GND in the power supply of the transponder key amplifier of the engine switch (VC5 - VC5) (1 trip detection logic*). |
| With the shift lever in P, the key held near the engine switch and an engine start operation is performed by pressing and holding the engine switch when the key battery is depleted. |
| Vehicle Condition when Malfunction Detected | Fail-safe Operation when Malfunction Detected |
| Engine cannot be started when key battery is depleted by holding key near engine switch and pressing and holding engine switch with shift lever in P | - |
| DTC Code | Data List and Active Test |
| B278A | - |

| 1.CHECK CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) |
Using an oscilloscope, check the waveform.

| *a | Component with harness connected (Engine Switch) | *b | Waveform |
| Tester Connection | Condition | Tool Setting | Specified Condition |
| I58-10 (VC5) - I58-6 (AGND) | Engine switch off, key not in cabin, within 30 seconds after engine switch pressed | 2 V/DIV., 200 ms./DIV. | Pulse generation (See waveform) |
| Result | Proceed to |
| NG | A |
| OK (for 2GR-FE) | B |
| OK (for 2AR-FE) | C |
| OK (for 6AR-FSE) | D |
|
| ||||
|
| ||||
|
| ||||
| A | |
| 2.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) - ENGINE SWITCH) |
Disconnect the I78 certification ECU (smart key ECU assembly) connector.
Disconnect the I58 engine switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I78-1 (VC5) - I58-10 (VC5) | Always | Below 1 Ω |
| I78-24 (AGND) - I58-6 (AGND) | Always | Below 1 Ω |
| I78-1 (VC5) or I58-10 (VC5) - Body ground | Always | 10 kΩ or higher |
| I78-24 (AGND) or I58-6 (AGND) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) |
Reconnect the I78 certification ECU (smart key ECU assembly) connector.
Reconnect the I58 engine switch connector.
Measure the voltage according to the value(s) in the table below.

| *a | Component with harness connected (Certification ECU (Smart Key ECU Assembly)) | - | - |
| Tester Connection | Condition | Specified Condition |
| I78-1 (VC5) - I78-24 (AGND) | Engine switch off, brake pedal not depressed, 30 seconds or more elapsed after driver door opened and then closed | Below 1 V |
| Result | Proceed to |
| OK (for 2GR-FE) | A |
| OK (for 2AR-FE) | B |
| OK (for 6AR-FSE) | C |
| NG | D |
|
| ||||
|
| ||||
|
| ||||
| A | ||
| ||