Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM (w/ Smart Entry and Start System)

DTC    B278D    Malfunction of ID-BOX Recognition

for Preparation Click here


DESCRIPTION

When the certification ECU (smart key ECU assembly) detects an input signal indicating that the vehicle is equipped with an ID code box (immobiliser code ECU) even though the ID code box (immobiliser code ECU) is not registered, the certification ECU (smart key ECU assembly) stores this DTC.

DTC Code
DTC Detection Condition
Trouble Area
DTC Output Confirmation Operation
B278D
The certification ECU (smart key ECU assembly) receives a LIN signal from the ID code box (immobiliser code ECU) even though the wire harness judging whether the vehicle is equipped with an ID code box (immobiliser code ECU) or not is not provided.
Misconnection of the ID code box (immobiliser code ECU)
Always

Vehicle Condition and Fail-safe Operation when Malfunction Detected 
Vehicle Condition when Malfunction Detected
Fail-safe Operation when Malfunction Detected
Key registration will be prohibited
-

Related Data List and Active Test 
DTC Code
Data List and Active Test
B278D
-

INSPECTION PROCEDURE

NOTICE:
  1. Before replacing the certification ECU (smart key ECU assembly), refer to the Service Bulletin.
  2. After performing repairs, perform the operation that fulfills the DTC output confirmation operation, and then confirm that no DTCs are output again.
  3. Before performing the following inspection procedure, check that the ID code box (immobiliser code ECU) is not installed on the vehicle.*
    *: w/ Entry Function on Driver Door except TMMK Made

1.CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


2.CHECK DTC OUTPUT
  1. Check for DTCs (Click here).

    HINT:
    Before checking for DTCs, perform the "DTC Output Confirmation Operation" procedure.

    OK:
    DTC B278D is not output.



NG
REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)
OK

END