STEERING PAD (for TMMK Made) > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE LOWER NO. 3 STEERING WHEEL COVER |
![]() |
Using a screwdriver with its tip wrapped with protective tape, disengage the claw and guide to remove the lower No. 3 steering wheel cover.
| *a | Protective Tape |
| 4. REMOVE LOWER NO. 2 STEERING WHEEL COVER |
![]() |
Using a screwdriver with its tip wrapped with protective tape, disengage the claw and guide to remove the lower No. 2 steering wheel cover.
| *a | Protective Tape |
| 5. REMOVE HORN BUTTON ASSEMBLY |
Check that the engine switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
![]() |
Using a screwdriver, push in the 3 torsion springs to disengage the 3 pins.
| *a | Torsion Spring |
Pull out the horn button assembly from the steering wheel assembly and support the horn button assembly with one hand.
![]() |
Disconnect the horn connector from the horn button assembly.
Using a screwdriver with its tip wrapped with protective tape, release the 2 airbag connector locks.
| *a | Protective Tape |
| *b | Airbag Connector |
| *c | Horn Connector |
| *d | Airbag Connector Lock |
Disconnect the 2 airbag connectors to remove the horn button assembly.