KNEE AIRBAG ASSEMBLY (for TMMK Made Driver Side) > INSTALLATION |
| 1. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY |
Check that the engine switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
![]() |
Connect the airbag connector to the lower No. 1 instrument panel airbag assembly.
| *1 | Airbag Connector |
| *2 | Airbag Connector Lock |
Push in the lock to install the airbag connector.
Temporarily install the lower No. 1 instrument panel airbag assembly with the 2 hooks.
Engage the 2 claws to install the DLC3.
Install the 4 bolts.
| 2. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL ASSEMBLY |
Engage the 4 claws, 9 clips and 3 guides.
Install the lower No. 1 instrument panel finish panel assembly with the bolt <B> and screw <C> or <D>.
| 3. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY |
Engage the claw and 2 guides to connect the hood lock control lever sub-assembly.
| 4. INSTALL INSTRUMENT SIDE PANEL LH |
Engage the 3 guides.
![]() |
Engage the 4 claws to install the instrument side panel LH as shown in the illustration.
| 5. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH |
| 6. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH |
Engage the 2 clips.
Install the cowl side trim sub-assembly LH with the clip.
| 7. INSTALL FRONT DOOR SCUFF PLATE LH |
Engage the 10 claws to install the front door scuff plate LH.
| 8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 9. PERFORM DIAGNOSTIC SYSTEM CHECK |
| 10. INSPECT SRS WARNING LIGHT |