AUTOMATIC TRANSAXLE SYSTEM > CHECK MODE PROCEDURE |
| DESCRIPTION |
Check mode has a higher sensitivity to malfunctions and can detect malfunctions that normal mode cannot detect. Check mode can also detect all of the malfunctions that normal mode can detect. In check mode, DTCs are detected with 1 trip detection logic.
| CHECK MODE PROCEDURE |
Make sure that the following conditions are met:
Turn the engine switch off.
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Powertrain / Transmission / Utility / Check Mode.
![]() |
Check that the MIL flashes as shown in the illustration.
Start the engine. The MIL should turn off after the engine starts.
Perform Monitor Drive Pattern for the ECT test (Click here).
(Or, simulate the conditions of the malfunction described by the customer.)
After simulating the malfunction conditions, use the GTS to check for DTCs and freeze frame data.