Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › PUSH-BUTTON START

PUSH-BUTTON START > PROBLEM SYMPTOMS TABLE

for Preparation Click here


HINT:
  1. Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
  2. Inspect the fuses and relays related to the system before inspecting the suspected areas below.
  3. If the problem occurs in certain locations or times of day, the possibility of wave interference is high.
  4. If a malfunction occurred after optional components were installed at the dealer, check if there is wave interference from the components.


Push-button Start 
Symptom
Suspected Area
See page
Power source mode does not change to on (IG) or on (ACC)
Refer to "Power Source Mode does not Change to ON (IG and ACC)"
Click here
Power source mode does not change to on (IG)
Refer to "Power Source Mode does not Change to ON (IG)"
Click here
Power source mode does not change to on (ACC)
Refer to "Power Source Mode does not Change to ON (ACC)"
Click here
Engine does not start
Refer to "Engine does not Start"
Click here
Room oscillator does not recognize key
Refer to "Oscillator does not Recognize Key"
Click here
Key luggage compartment lock-in prevention function does not operate
Refer to "Key Luggage Compartment Lock-in Prevention Function does not Operate"
Click here