Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM

DTC    C1225    SM Solenoid Circuit

DTC    C1226    SA2 Solenoid Circuit

DTC    C1227    SA3 Solenoid Circuit

DTC    C1228    STR Solenoid Circuit

DTC    C1468    SFR Solenoid Circuit

DTC    C1469    SFL Solenoid Circuit

DTC    C146A    SRR Solenoid Circuit

DTC    C146B    SRL Solenoid Circuit

for Preparation Click here


DESCRIPTION

These solenoids turn on when signals are received from the skid control ECU and they control the pressure acting on the wheel cylinders to control the braking force.

DTC No.
DTC Detection Condition
Trouble Area
C1225
C1226
C1227
C1228
C1468
C1469
C146A
C146B
Solenoid valve signal does not match the check result.
  1. Solenoid circuit
  2. Solenoid valve (Brake actuator assembly)

WIRING DIAGRAM

Refer to DTC C146E (Click here).

INSPECTION PROCEDURE

1.RECONFIRM DTC

HINT:
These codes are detected when a problem is determined in the brake actuator assembly.
The solenoid circuits are in the brake actuator assembly.
Therefore, solenoid circuit inspection and solenoid unit inspection cannot be performed. Be sure to check if any DTC is output before replacing the brake actuator assembly.

  1. Clear the DTCs (Click here).

  1. Turn the ignition switch off.

  1. Start the engine.

  1. Drive the vehicle at a speed of 20 km/h (12 mph) or more.

  1. Check if the same DTC is output (Click here).

    Result:

    Result
    Proceed to
    DTCs C1225, C1226, C1227, C1228, C1468, C1469, C146A and C146B are not output.
    A
    DTCs C1225, C1226, C1227, C1228, C1468, C1469, C146A and/or C146B are output.
    B

    HINT:
    1. The skid control ECU performs self diagnosis of the solenoid circuit after the ignition switch turned to ON.
    2. If the normal system code is output (No DTCs are output), slightly jiggle the connectors, wire harness, and fuses of the brake actuator assembly.
    3. If any DTCs are output while jiggling a connector or wire harness of the skid control ECU (brake actuator assembly), inspect and repair the connector or wire harness.
    4. If no DTCs were output when reconfirming DTCs, checking for intermittent problems is necessary because it is suspected that the original DTCs were stored due to the poor connection of a connector terminal.



B
REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)
A

CHECK FOR INTERMITTENT PROBLEMS (Click here)