TIRE PRESSURE WARNING SYSTEM > TC and CG Terminal Circuit |

| 1.CHECK CAN COMMUNICATION SYSTEM |
Check if CAN communication system DTCs are output (Click here).
| Result | Proceed to |
| DTCs are not output. | A |
| DTCs are output. | B |
|
| ||||
| A | |
| 2.CHECK DTC (C2179/79) |
Check if DTC C2179/79 is output (Click here).
| Result | Proceed to |
| DTC C2179/79 is not output. | A |
| DTC C2179/79 is output. | B |
|
| ||||
| A | |
| 3.CHECK HARNESS AND CONNECTOR (TC of DLC3 - ECM) |
Disconnect the A25 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I39-13 (TC) - A25-23 (TC) | Always | Below 1 Ω |
| I39-13 (TC) or A25-23 (TC) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (CG of DLC3 - BODY GROUND) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I39-4 (CG) - Body ground | Always | Below 1 Ω |
| *a | Front view of DLC3 |
|
| ||||
| OK | |
| 5.INSPECT DLC3 TERMINAL VOLTAGE (TC VOLTAGE) |
Reconnect the A25 ECM connector.
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I39-13 (TC) - I39-4 (CG) | Ignition switch ON | 11 to 14 V |
| *a | Front view of DLC3 |
|
| ||||
| OK | ||
| ||