HOOD LOCK CONTROL CABLE ASSEMBLY (for TMC, TMMR Made) > INSTALLATION |
| 1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY (for LHD) |
Pass the hood lock control cable assembly into the engine compartment.
Pass the cable through the upper radiator support.
Engage the hood cable grommet.
Engage the 5 clamps and install the hood lock control cable assembly.
| 2. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY (for RHD) |
Pass the hood lock control cable assembly into the engine compartment.
Pass the cable through the upper radiator support.
Engage the hood cable grommet.
Engage the 4 clamps and install the hood lock control cable assembly.
| 3. INSTALL HOOD LOCK ASSEMBLY (for LHD) |
![]() |
Apply MP grease to the sliding areas of the lock.
Connect the hood lock control cable assembly.
Install the hood lock assembly with the 2 bolts and hood lock bolt.
Connect the connector.
| 4. INSTALL HOOD LOCK ASSEMBLY (for RHD) |
![]() |
Apply MP grease to the sliding areas of the lock.
Connect the hood lock control cable assembly.
Install the hood lock assembly with the 2 bolts and hood lock bolt.
Connect the connector.
| 5. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY |
Connect the hood lock control cable assembly and install the hood lock control lever sub-assembly.
| 6. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY |
Engage the claw and 2 guides to connect the hood lock control lever sub-assembly.
| 7. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH (for LHD) |
Engage the 2 clips.
Install the cowl side trim sub-assembly LH with the clip.
| 8. INSTALL FRONT DOOR SCUFF PLATE LH (for LHD) |
Engage the 10 claws to install the front door scuff plate LH.
| 9. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH (for RHD) |
| 10. INSTALL FRONT DOOR SCUFF PLATE RH (for RHD) |
| 11. INSTALL FRONT FENDER LINER LH (for LHD) |
| 12. INSTALL FRONT WHEEL OPENING EXTENSION PAD LH (for LHD) |
| 13. INSTALL FRONT WHEEL LH (for LHD) |
| 14. INSTALL FRONT FENDER LINER RH (for RHD) |
for TMC, TMMR Made:
Install the front fender liner RH with the 4 clips and 5 screws.
Install 2 new grommets.
![]() |
Install the pin hold clip as shown in the illustration.
| *1 | Clip |
| *2 | Pin Hold Clip |
| *a | Correct |
| *b | Incorrect |
Install the clip.
for TMMK Made:
Install the front fender liner RH with the 4 clips.
Install 3 new grommets.
Install the 5 screws and bolt.
![]() |
Install the pin hold clip as shown in the illustration.
| *1 | Clip |
| *2 | Pin Hold Clip |
| *a | Correct |
| *b | Incorrect |
Install the clip.
| 15. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH (for RHD) |
for TMC, TMMR Made:
Install the front wheel opening extension pad RH with the 3 screws.
for TMMK Made:
Install the front wheel opening extension pad RH with the 3 screws.
| 16. INSTALL FRONT WHEEL RH (for RHD) |
| 17. INSTALL FRONT BUMPER ASSEMBLY |
| 18. ADJUST HOOD SUB-ASSEMBLY |