Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM (for Models with Jam Protection Function on 4 Windows)

POWER WINDOW CONTROL SYSTEM (for Models with Jam Protection Function on 4 Windows) > Jam Protection Function does not Operate

for Preparation Click here


DESCRIPTION

This symptom may occur for any of the windows.
The jam protection function operates within a specified range during the manual up or auto up operation.

INSPECTION PROCEDURE

NOTICE:
If a power window regulator motor assembly has been replaced with a new one, initialize the power window control system (Click here).

1.PERFORM INITIALIZATION (APPLICABLE LOCATION)
  1. Initialize the power window regulator motor assembly (applicable location) (Click here).


NEXT


2.CHECK POWER WINDOW CONTROL SYSTEM (AUTO UP/DOWN FUNCTION)
  1. Check if the power window auto up and down functions operate normally (Click here).

    OK:
    Auto up and down functions are normal.



NG
GO TO OTHER PROBLEM (Proceed to Problem Symptoms Table) (Click here)
OK


3.CHECK JAM PROTECTION FUNCTION OPERATING RANGE
  1. Check if the jam protection function operates normally for the applicable power window.

    HINT:
    The jam protection function will not operate within 4 mm (0.157 in.) of the fully closed position.

    OK:
    Jam protection function operates normally.

    Result:
    Result
    Proceed to
    OK
    A
    NG (Driver door power window)
    B
    NG (Front passenger door power window)
    B
    NG (Rear LH door power window)
    C
    NG (Rear RH door power window)
    C



B
REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR DRIVER DOOR OR FRONT PASSENGER DOOR) (Click here)

C
REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR REAR LH DOOR OR REAR RH DOOR) (Click here)
A

END (PROBLEM DUE TO INITIALIZATION FAILURE)