STARTER > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE COOL AIR INTAKE DUCT SEAL |
![]() |
Remove the 9 clips and cool air intake duct seal.
| 4. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY |
![]() |
Disengage the 3 grommets to remove the No. 1 engine cover sub-assembly.
| 5. REMOVE INLET AIR CLEANER ASSEMBLY |
![]() |
Remove the 2 bolts and inlet air cleaner assembly.
| 6. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE |
![]() |
Slide the clip and disconnect the ventilation hose from the cylinder head cover sub-assembly.
Disengage the ventilation hose clamp.
![]() |
Disconnect the mass air flow meter sub-assembly connector.
Disengage the wire harness clamp.
![]() |
Disconnect the union to connector tube hose from the air cleaner hose sub-assembly.
Disengage the 2 air cleaner cap clamps and 2 guides.
![]() |
Loosen the hose clamp and remove the air cleaner cap with air cleaner hose from the throttle body with motor assembly.
| 7. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY |
Remove the air cleaner filter element sub-assembly from the air cleaner case sub-assembly.
| 8. REMOVE AIR CLEANER CASE SUB-ASSEMBLY |
![]() |
Disconnect the wire harness clamp.
Remove the 2 bolts and air cleaner case sub-assembly.
| 9. REMOVE BATTERY |
![]() |
Loosen the nut, and disconnect the cable from the positive (+) battery terminal.
Loosen the nut, and remove the bolt and battery clamp.
Remove the battery and battery tray.
| 10. REMOVE STARTER ASSEMBLY |
![]() |
Open the terminal cap.
| *1 | Terminal Cap |
Remove the nut and disconnect terminal 30.
Disconnect the starter assembly connector.
![]() |
Remove the 2 bolts and starter assembly.