REPAIR INSTRUCTION > INITIALIZATION |
| PROCEDURES NECESSARY WHEN BATTERY TERMINAL IS DISCONNECTED/RECONNECTED |
| Necessary Procedures | Effect/Inoperative Function When Necessary Procedures are not Performed | See page |
| Correct the steering angle neutral point | Parking assist monitor system |
Click here
|
| PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED |
| Replacement Part | Necessary Procedure | Effect/Inoperative Function when Necessary Procedures are not Performed | See page | |
| ECM | Perform Vehicle Identification Number (VIN) or frame number registration | MIL comes on |
Click here for 2AR-FE Click here for 2GR-FE Click here for 6AR-FSE | |
| ECM | Code registration (Engine immobiliser system) | Engine start | See Service Bulletin for the registration method. | |
| Inspection after repair |
|
Click here for 2AR-FE Click here for 2GR-FE | |
| Inspection after repair |
|
Click here for 6AR-FSE | |
| Automatic transaxle assembly |
|
|
Click here for U660E Initialization Click here for U660E Registration | |
|
|
| ||
| Shift solenoid valve SL1 and/or SL2 | Perform road test to allow TCM to learn |
| ||
| TCM (If possible, read the transaxle compensation code from the previous TCM) | Possible |
|
| |
| Impossible |
|
| ||
| Automatic transaxle assembly |
|
|
Click here for U760E Initialization Click here for U760E Registration Click here for U761E Initialization Click here for U761E Registration | |
|
|
| ||
| Shift solenoid valve SL1 and/or SL2 | Perform road test to allow ECM to learn |
| ||
| ECM (If possible, read the transaxle compensation code from the previous ECM) | Possible |
|
| |
| Impossible |
|
| ||
| Skid control ECU (Brake actuator assembly) | Perform system variant learning |
|
Click here
| |
| Power steering ECU assembly |
|
|
Click here
| |
| Electric power steering column sub-assembly | Torque sensor zero point calibration | Steering effort is different between turning steering wheel to left and right | ||
| Steering sensor |
| Parking assist monitor system |
Click here for Initialization Click here for Calibration | |
| Suspension, tires, etc. | Rear television camera assembly optical axis (Back camera position setting) | Parking assist monitor system | ||
| Rear television camera assembly |
| Parking assist monitor system | ||
| Blind spot monitor sensor | Blind spot monitor beam axis inspection | DTCs are output |
Click here
| |
| Code registration (Engine immobiliser system) |
| See Service Bulletin for the registration method. | |
| Code registration (Engine immobiliser system) | Engine start | See Service Bulletin for the registration method. | |
| Code registration (Wireless door lock system) | Wireless door lock control system |
Click here
| |
| Zero point calibration and sensitivity check (Occupant classification system) |
|
Click here
| |
| Servo motor initialization (Air conditioning system) | DTCs are output |
Click here
| |
| Initialize power window control system |
|
Click here
| |
| Initialize power window control system |
|
Click here
| |
| Initialize sliding roof ECU (pulse sensor initial position setting) |
|
Click here
| |
| Perform AFS ECU initialization | AFS function |
Click here
| |
| Perform Headlight leveling ECU initialization | Automatic headlight beam level control function |
Click here
| |