TRANSMISSION CONTROL CABLE > INSTALLATION |
| 1. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY |
Pass the transmission control cable assembly from the cabin to the engine compartment.
Install the transmission control cable assembly with the 2 bolts.
Install the dash panel insulator to its original position.
Connect the transmission control cable assembly to the No. 1 transmission control cable bracket with a new clip.
Connect the transmission control cable assembly to the transmission control shaft lever with the nut.
Engage the clamp to connect the engine wire to the automatic transaxle assembly.
Install the nut to the wire harness clamp bracket.
![]() |
Slide the slider of the transmission control cable assembly as shown in the illustration and pull the lock piece outward.
| *a | Slider |
| *b | Lock Piece |
| *c | Slide |
| *d | Pull |
![]() |
Engage the 2 claws to connect the transmission control cable assembly to the lower shift lever assembly.
| *a | Lock Piece |
Connect the end of the transmission control cable assembly to the lower shift lever assembly.
Push the lock piece into the adjuster case.
| 2. CONNECT NO. 1 PARKING BRAKE CABLE ASSEMBLY |
Connect the No. 1 parking brake cable assembly to the vehicle body with the bolt and nut.
Install the floor carpet to its original position.
| 3. INSTALL ACCELERATOR PEDAL SENSOR ASSEMBLY |
| 4. INSTALL AIRBAG SENSOR ASSEMBLY |
| 5. INSTALL AIR CLEANER CASE SUB-ASSEMBLY |
![]() |
Insert the projection of the air cleaner case sub-assembly to the hole of the No. 2 air cleaner bracket as shown in the illustration.
| *a | Wire harness clamp |
| *b | Hole |
| *c | Projection |
Tighten the 2 bolts.
Connect the wire harness clamp.
| 6. INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY |
Install the air cleaner filter element sub-assembly to the air cleaner case sub-assembly.
| 7. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE |
Connect the air cleaner cap with air cleaner hose to the throttle body with motor assembly.
Install the air cleaner cap with air cleaner hose with the 2 guides and 2 air cleaner cap clamps.
Tighten the hose clamp.
Connect the union to connector tube hose to the air cleaner hose sub-assembly.
Engage the wire harness clamp.
Connect the mass air flow meter sub-assembly connector.
Engage the ventilation hose clamp.
Connect the ventilation hose to the cylinder head cover sub-assembly and slide the clip to secure it.
| 8. INSTALL INLET AIR CLEANER ASSEMBLY |
Install the inlet air cleaner assembly with the 2 bolts.
| 9. INSTALL COOL AIR INTAKE DUCT SEAL |
Install the cool air intake duct seal with the 9 clips.
| 10. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY |
Engage the 3 grommets to install the No. 1 engine cover sub-assembly.
| 11. INSPECT SHIFT LEVER POSITION |
When the shift lever is moved from P to R with the engine switch ON and brake pedal depressed, make sure that the shift lever moves smoothly and correctly to P.
Start the engine and check that the vehicle moves forward when the shift lever is moved from N to D and moves rearward when the shift lever is moved to R.