Home › Drivetrain ยท U660E AUTOMATIC TRANSMISSION / TRANSAXLE › TRANSMISSION CONTROL CABLE

TRANSMISSION CONTROL CABLE > REMOVAL

for Preparation Click here



1. REMOVE COOL AIR INTAKE DUCT SEAL


    B382622
  1. Remove the 9 clips and cool air intake duct seal.



2. REMOVE INLET NO. 2 AIR CLEANER


    A255421
  1. Disconnect the 2 wire harness clamps and vacuum hose clamp.

  1. Remove the 2 bolts and inlet No. 2 air cleaner.



3. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    A254996
  1. Disconnect the mass air flow meter connector and wire harness clamp.



    A254997
  1. Disconnect the 3 hoses.

  1. Separate the ventilation hose.



    A254998
  1. Loosen the hose clamp and separate the air cleaner cap sub-assembly from the throttle with motor body assembly.

  1. Release the 2 clamps and remove the air cleaner cap with hose.



4. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY


5. REMOVE AIR CLEANER CASE SUB-ASSEMBLY


    A255892
  1. Disconnect the wire harness clamp, connector, vacuum hose and No. 1 fuel vapor feed hose.

  1. Remove the 2 bolts and air cleaner case sub-assembly.



6. REMOVE AIRBAG SENSOR ASSEMBLY
(Click here)


7. REMOVE ACCELERATOR PEDAL SENSOR ASSEMBLY

NOTICE:
  1. Avoid physical shock to the accelerator pedal sensor assembly.
  2. Do not disassemble the accelerator pedal sensor assembly.
  3. The accelerator pedal sensor assembly does not require lubrication.
  4. Do not apply oil or other lubricants to the accelerator pedal sensor assembly. If applied, the accelerator pedal sensor assembly must be replaced.



    A254796
  1. Disconnect the accelerator pedal sensor assembly connector.

  1. Remove the 2 bolts and accelerator pedal sensor assembly.



8. DISCONNECT NO. 1 PARKING BRAKE CABLE ASSEMBLY
  1. Turn back the floor carpet.



    C240462
  1. Remove the bolt and nut, and disconnect the No. 1 parking brake cable assembly.



9. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY
  1. Move the shift lever to N.



    C343695
  1. Disconnect the end of the transmission control cable assembly from the lower shift lever assembly.

  1. Disengage the 2 claws and disconnect the transmission control cable assembly from the lower shift lever assembly.



    C239656
  1. Disconnect the wire harness clamp.



    C239668
  1. Remove the nut and clip, and disconnect the transmission control cable assembly.



    C240463
  1. Turn back the dash panel insulator.

  1. Remove the 2 bolts and pull out the transmission control cable assembly from the body.