Home › Drivetrain ยท U761E AUTOMATIC TRANSMISSION / TRANSAXLE › TRANSMISSION CONTROL CABLE

TRANSMISSION CONTROL CABLE > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    A338523
  1. Disengage the 3 grommets to remove the No. 1 engine cover sub-assembly.

    NOTICE:
    When removing the No. 1 engine cover sub-assembly, make sure to lift it upward. Pulling the No. 1 engine cover sub-assembly towards you may damage the No. 1 engine cover sub-assembly.



2. REMOVE COOL AIR INTAKE DUCT SEAL


    B382622
  1. Remove the 9 clips and cool air intake duct seal.



3. REMOVE INLET AIR CLEANER ASSEMBLY


    A338524
  1. Remove the 2 bolts and inlet air cleaner assembly.



4. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE


    A337994
  1. Slide the clip and disconnect the ventilation hose from the cylinder head cover sub-assembly.

  1. Disengage the ventilation hose clamp.



    A337996
  1. Disconnect the mass air flow meter sub-assembly connector.

  1. Disengage the wire harness clamp.



    A337995
  1. Disconnect the union to connector tube hose from the air cleaner hose sub-assembly.

  1. Disengage the 2 air cleaner cap clamps and 2 guides.



    A337997
  1. Loosen the hose clamp and remove the air cleaner cap with air cleaner hose from the throttle body with motor assembly.



5. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
  1. Remove the air cleaner filter element sub-assembly from the air cleaner case sub-assembly.



6. REMOVE AIR CLEANER CASE SUB-ASSEMBLY


    A338951
  1. Disconnect the wire harness clamp.

  1. Remove the 2 bolts and air cleaner case sub-assembly.



7. REMOVE AIRBAG SENSOR ASSEMBLY
(Click here)


8. REMOVE ACCELERATOR PEDAL SENSOR ASSEMBLY



9. DISCONNECT NO. 1 PARKING BRAKE CABLE ASSEMBLY
  1. Turn back the floor carpet.



    C240462
  1. Remove the bolt and nut, and disconnect the No. 1 parking brake cable assembly from the vehicle body.



10. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY
  1. Move the shift lever to N.



    C343695
  1. Disconnect the end of the transmission control cable assembly from the lower shift lever assembly.

  1. Disengage the 2 claws and disconnect the transmission control cable assembly from the lower shift lever assembly.



    C316899
  1. Remove the nut from the wire harness clamp bracket.

  1. Disengage the clamp and disconnect the engine wire from the automatic transaxle assembly.



    C316900
  1. Remove the clip and disconnect the transmission control cable assembly from the No. 1 transmission control cable bracket.



    C316901
  1. Remove the nut and disconnect the transmission control cable assembly from the transmission control shaft lever.



    C240463E02
  1. Turn back the dash panel insulator.
    Text in Illustration 
    *a
    Dash Panel Insulator

  1. Remove the 2 bolts and transmission control cable assembly.