TORQUE CONVERTER AND DRIVE PLATE > INSPECTION |
| 1. INSPECT TORQUE CONVERTER ASSEMBLY |
Inspect the one-way clutch.
![]() |
Press on the splines of the stator with a finger and rotate the spline. Check that the spline rotates smoothly when turned clockwise and rotates with difficulty when turned counterclockwise.
![]() | Difficult |
![]() | Smooth |
![]() |
Inspect the torque converter assembly.
| *a | Sample showing maximum allowable amount of powder in ATF |
| *b | Full Scale |
Replace the ATF in the torque converter assembly.
![]() |
Prevent deformation of the torque converter assembly and damage to the oil pump gear.
| *a | Correct |
| *b | Incorrect |
| *c | Bottom is damaged |
| 2. INSPECT DRIVE PLATE AND RING GEAR SUB-ASSEMBLY |
Check the drive plate and ring gear sub-assembly for damage.
![]() |
Set up a dial indicator and measure the runout at the 6 areas on the drive plate and ring gear sub-assembly surface that contact the torque converter assembly.
![]() | Measuring Point |