Home › Engine / Hybrid System ยท 6AR-FSE › ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL

REAR CRANKSHAFT OIL SEAL > INSTALLATION

for Preparation Click here



1. INSTALL REAR ENGINE OIL SEAL
  1. Using height adjustment attachments and plate lift attachments, place the engine assembly on a flat level surface.

    NOTICE:
    1. Using height adjustment attachments and plate lift attachments, place the engine assembly horizontally.
    2. To prevent the oil pan sub-assembly from deforming, do not place any attachments under the oil pan sub-assembly of the engine assembly.
    3. Using an engine sling device and engine lift, secure the engine assembly before service.

  1. Remove any old seal packing.



    A342966E01
  1. Apply seal packing in a continuous line as shown in the illustration.
    Text in Illustration 
    *a
    Seal Packing
    *b
    3.0 mm (0.118 in.)

    Seal packing:
    Toyota Genuine Seal Packing Black, Three Bond 1207B or equivalent

    NOTICE:
    1. Remove any oil from the contact surfaces.
    2. Install a new rear engine oil seal within 3 minutes of applying seal packing.
    3. Do not start the engine for at least 2 hours after installation.

  1. Apply MP grease to the lip of a new rear engine oil seal.

    NOTICE:
    1. Keep the lip free from foreign matter.
    2. Do not allow MP grease to contact the dust seal.



    A337176E01
  1. Using SST and a hammer, tap in the rear engine oil seal.
    Text in Illustration 
    *a
    Standard Depth (from edge of cylinder block sub-assembly)

    SST
    09223-15030  
    09950-70010   (09951-07150)

    Standard Depth:
    -0.2 to 0.9 mm (-0.00787 to 0.0354 in.)

    NOTICE:
    1. Keep the lip free from foreign matter.
    2. Do not tap in the rear engine oil seal at an angle.



2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    A337180E01
  1. Using SST, hold the crankshaft.

    SST
    09213-54015  
    09330-00021  

    HINT:
    Part number of installation bolt for SST (crankshaft pulley holding tool): 91551-80650 (quantity: 2)

  1. Clean the 8 bolts and the bolt holes.



    A337178
  1. Install the front drive plate spacer.

    HINT:
    Align the pin of the front drive plate spacer with the pin hole of the crankshaft.



    A337179E01
  1. Install the drive plate and ring gear sub-assembly and rear drive plate spacer to the crankshaft.
    Text in Illustration 
    *1
    Drive Plate and Ring Gear Sub-assembly
    *2
    Rear Drive Plate Spacer
    V100135
    Transaxle Side



    A192239E20
  1. Apply adhesive to 2 or 3 threads at the end of each of the 8 bolts.
    Text in Illustration 
    *a
    Adhesive

    Adhesive:
    Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent



    A337181E01
  1. Install and uniformly tighten the 8 bolts in several steps in the sequence shown in the illustration.

    Torque:
    98 N*m{ 999 kgf*cm , 72 ft.*lbf }

    NOTICE:
    Do not start the engine for at least 1 hour after installing the drive plate and ring gear sub-assembly.



3. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY
(Click here)