Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY (for TMC, TMMR Made Power Seat)

FRONT SEAT ASSEMBLY (for TMC, TMMR Made Power Seat) > INSTALLATION

for Preparation Click here


CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The following procedure is for the LH side.



1. INSTALL FRONT SEAT ASSEMBLY
  1. Place the front seat assembly in the cabin.

    NOTICE:
    Be careful not to damage the vehicle body.

  1. Connect each connector and clamp under the seat.

  1. Connect the cable to the negative (-) battery terminal.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  1. Temporarily install the front seat assembly with the 4 bolts.

  1. Operate the slide and vertical power seat switch knob and move the seat to the rearmost position.



    B281471E01
  1. Tighten the 2 bolts on the front side of the seat.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

    NOTICE:
    Tighten the bolts in the order indicated in the illustration.

  1. Operate the slide and vertical power seat switch knob and move the seat to the foremost position.



    B281472E01
  1. Tighten the 2 bolts on the rear side of the seat.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

    NOTICE:
    Tighten the bolts in the order indicated in the illustration.



2. INSTALL REAR INNER SEAT TRACK BRACKET COVER
  1. Engage the 2 claws to install the rear inner seat track bracket cover.



3. INSTALL REAR OUTER SEAT TRACK BRACKET COVER
  1. Engage the 2 claws to install the rear outer seat track bracket cover.



4. INSTALL FRONT INNER SEAT TRACK BRACKET COVER
  1. Operate the slide and vertical power seat switch knob and move the seat to the rearmost position.

  1. Engage the 2 claws to install the front inner seat track bracket cover.



5. INSTALL FRONT OUTER SEAT TRACK BRACKET COVER
  1. Engage the 2 claws to install the front outer seat track bracket cover.



6. INSTALL FRONT SEAT HEADREST ASSEMBLY


7. INSPECT FRONT SEAT ASSEMBLY
  1. Check the power seat operation.

    1. w/o Memory: (Click here)

    2. w/ Memory: (Click here)

  1. w/ Seat Heater System:
    Check the seat heater operation.

    1. Turn the ignition switch to ON.

    2. Turn the seat heater switch on.

    3. Wait 5 minutes or more and confirm that the seat surface becomes warm.



8. INSPECT SRS WARNING LIGHT
(Click here)