Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY (for TMC, TMMR Made Power Seat)

FRONT SEAT ASSEMBLY (for TMC, TMMR Made Power Seat) > REMOVAL

for Preparation Click here


CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The following procedure is for the LH side.



1. PRECAUTION

CAUTION:
  1. Be sure to read precaution thoroughly before servicing (Click here).
  2. If the side airbag has deployed, replace the front seat airbag assembly, separate type front seatback spring assembly, separate type front seatback pad and separate type front seatback cover with the necessary parts in accordance with the extent of the collision damage.

NOTICE:
  1. After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (Click here).



2. REMOVE FRONT SEAT HEADREST ASSEMBLY


3. REMOVE FRONT OUTER SEAT TRACK BRACKET COVER
  1. Operate the slide and vertical power seat switch knob and move the seat to the rearmost position.



    B281485
  1. Disengage the 2 claws to remove the front outer seat track bracket cover.



4. REMOVE FRONT INNER SEAT TRACK BRACKET COVER


    B281483
  1. Disengage the 2 claws to remove the front inner seat track bracket cover.



5. REMOVE REAR OUTER SEAT TRACK BRACKET COVER
  1. Operate the slide and vertical power seat switch knob and move the seat to the foremost position.



    B280204
  1. Disengage the 2 claws to remove the rear outer seat track bracket cover.



6. REMOVE REAR INNER SEAT TRACK BRACKET COVER


    B280203
  1. Disengage the 2 claws to remove the rear inner seat track bracket cover.



7. REMOVE FRONT SEAT ASSEMBLY


    B281091
  1. Remove the 2 bolts on the rear side of the seat.

  1. Operate the slide and vertical power seat switch knob and move the seat to the rearmost position.

  1. Remove the 2 bolts on the front side of the seat.

  1. Operate the slide and vertical power seat switch knob and move the seat to the center position. Then, operate the reclining power seat switch knob and move the seatback to the upright position.

  1. Disconnect the cable from the negative (-) battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  1. Disconnect each connector and clamp under the seat.

  1. Remove the front seat assembly.

    NOTICE:
    Be careful not to damage the vehicle body.