SFI SYSTEM > Fuel Injector Circuit |

| 1.CHECK TERMINAL VOLTAGE (POWER SOURCE OF FUEL INJECTOR ASSEMBLY) |
![]() |
Disconnect the fuel injector assembly connectors.
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| E29-1 - Body ground | Ignition switch ON | 11 to 14 V |
| E34-1 - Body ground | Ignition switch ON | 11 to 14 V |
| E31-1 - Body ground | Ignition switch ON | 11 to 14 V |
| E35-1 - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector (to Fuel Injector Assembly) |
|
| ||||
| OK | |
| 2.INSPECT FUEL INJECTOR ASSEMBLY (INJECTION AND VOLUME) |
Check the fuel injector assembly injection and volume (Click here).
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (FUEL INJECTOR ASSEMBLY - ECM) |
Disconnect the ECM connector.
Disconnect the fuel injector assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E29-2 - E26-20 | Always | Below 1 Ω |
| E34-2 - E26-17 | Always | Below 1 Ω |
| E31-2 - E26-18 | Always | Below 1 Ω |
| E35-2 - E26-19 | Always | Below 1 Ω |
| E29-2 or E26-20 - Body ground | Always | 10 kΩ or higher |
| E34-2 or E26-17 - Body ground | Always | 10 kΩ or higher |
| E31-2 or E26-18 - Body ground | Always | 10 kΩ or higher |
| E35-2 or E26-19 - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||
| 4.CHECK HARNESS AND CONNECTOR (NO. 1 INTEGRATION RELAY - FUEL INJECTOR ASSEMBLY) |
Disconnect the fuel injector assembly connector.
Remove the No. 1 integration relay from the engine room relay block and junction block assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E29-1 - 1A-3 | Always | Below 1 Ω |
| E34-1 - 1A-3 | Always | Below 1 Ω |
| E31-1 - 1A-3 | Always | Below 1 Ω |
| E35-1 - 1A-3 | Always | Below 1 Ω |
| E29-1, E34-1, E31-1, E35-1 or 1A-3 - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||