Home
›
Vehicle Interior
›
SUPPLEMENTAL RESTRAINT SYSTEMS
›
OCCUPANT CLASSIFICATION SYSTEM (for TMMK Made)
OCCUPANT CLASSIFICATION SYSTEM (for TMMK Made) > PRECAUTION
for Preparation
Click here
1.PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable from the negative (-) battery terminal, initialize the following system(s) after the cable is reconnected:
System
See Procedure
Parking Assist Monitor System
Click here
2.GENERAL PRECAUTION
Perform zero point calibration and sensitivity check if any of the following conditions occur:
The occupant detection ECU is replaced.
Accessories (seatback tray and seat cover, etc.) are installed.
The front passenger seat is removed from the vehicle.
One of the bolts that is used to install the front passenger seat is removed and reinstalled.
The passenger airbag ON/OFF indicator ("ON") comes on when the front passenger seat is not occupied.
The vehicle is brought to the workshop for repair due to an accident or a collision.