Home › Suspension › FRONT SUSPENSION › FRONT LOWER BALL JOINT

FRONT LOWER BALL JOINT > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The procedure listed below is for the LH side.



1. REMOVE FRONT AXLE ASSEMBLY
(Click here)


2. REMOVE FRONT LOWER BALL JOINT ASSEMBLY
  1. Secure the front axle assembly in a vise using aluminum plates.

    NOTICE:
    When using a vise, do not overtighten it.



    C207073
  1. Remove the cotter pin and nut.



    C165932E02
  1. Install SST to the front lower ball joint assembly as shown in the illustration.

    SST
    09960-20010   (09961-02050, 09961-02050)

    NOTICE:
    Check that the clearance measurement between SST and the front axle assembly is 1 mm (0.0394 in.).



    C238957E01
  1. Using SST, remove the front lower ball joint assembly from the front axle assembly as shown in the illustration.

    SST
    09960-20010   (09961-02010, 09961-02050, 09961-02050)
    Text in Illustration 
    *a
    Apply grease
    *b
    Place wrench here

    CAUTION:
    Apply grease to the threads and end of the SST bolt.

    NOTICE:
    1. Install SST so that A and B are parallel.
    2. Be sure to place a wrench on the part indicated in the illustration.
    3. Do not damage the front lower ball joint dust cover.