REAR SHOCK ABSORBER (for TMC, TMMR Made) > REMOVAL |
| 1. REMOVE REAR SIDE SEATBACK ASSEMBLY (for Fold Down Seat Type) |
| 2. REMOVE REAR SEATBACK ASSEMBLY (for Reclining Seat Type) |
| 3. REMOVE REAR WHEEL |
| 4. SEPARATE REAR STABILIZER LINK ASSEMBLY |
![]() |
Remove the nut and separate the rear stabilizer link assembly from the rear shock absorber assembly.
If the ball joint turns together with the nut, use a hexagon wrench to hold the stud.
| 5. SEPARATE SKID CONTROL SENSOR WIRE |
![]() |
Remove the 2 bolts, and disconnect the rear flexible hose and skid control sensor wire from the rear shock absorber assembly.
| 6. REMOVE REAR NO. 1 SUSPENSION SUPPORT COVER |
![]() |
Using a screwdriver, disengage the 4 claws and remove the rear No. 1 suspension support cover.
| 7. REMOVE REAR SHOCK ABSORBER WITH COIL SPRING |
![]() |
Support the rear axle carrier sub-assembly with a jack using a wooden block.
| *1 | Jack |
| *2 | Wooden Block |
![]() |
Loosen the rear support to rear shock absorber nut of the rear shock absorber assembly.
![]() |
Remove the 2 bolts and 2 nuts, and separate the rear shock absorber with coil spring from the rear axle carrier sub-assembly.
![]() |
Remove the 3 nuts and rear shock absorber with coil spring.
| 8. REMOVE REAR SUPPORT TO REAR SHOCK ABSORBER NUT |
![]() |
Secure SST in a vise.
![]() |
Attach the arm of SST to the diameter of the rear coil spring.
Using SST, compress the rear coil spring.
Confirm that the rear coil spring becomes free and remove the rear support to rear shock absorber nut.
| 9. REMOVE REAR SUPPORT TO REAR SHOCK ABSORBER COLLAR |
| 10. REMOVE REAR SUSPENSION SUPPORT ASSEMBLY |
| 11. REMOVE REAR COIL SPRING |
| 12. REMOVE REAR NO. 1 SPRING BUMPER |
| 13. REMOVE REAR LOWER COIL SPRING INSULATOR |
| 14. REMOVE REAR SHOCK ABSORBER ASSEMBLY |