LIGHTING SYSTEM > Rear Door Courtesy Switch Circuit |

| 1.READ VALUE USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Main Body / Data List.
Read the display on the intelligent tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| RR Door Courtesy SW | Rear door courtesy light switch RH signal/ON or OFF | ON: Rear door RH open OFF: Rear door RH closed | - |
| RL Door Courtesy SW | Rear door courtesy light switch LH signal/ON or OFF | ON: Rear door LH open OFF: Rear door LH closed | - |
| Result | Proceed to |
| OK | A |
| Rear door courtesy light switch LH or RH does not operate | B |
|
| ||||
| A | ||
| ||
| 2.INSPECT REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY (LH OR RH) |
Remove the rear door courtesy light switch assembly (for TMC, TMMR Made) (Click here).
Remove the rear door courtesy light switch assembly (for TMMK Made) (Click here).
Inspect the rear door courtesy light switch assembly (for TMMK Made) (Click here).
Inspect the rear door courtesy light switch assembly (for TMC, TMMR Made) (Click here).
| Result | Proceed to |
| OK (for Rear LH) | A |
| OK (for Rear RH) | B |
| NG (for TMC, TMMR Made) | C |
| NG (for TMMK Made) | D |
|
| ||||
|
| ||||
|
| ||||
| A | |
| 3.CHECK HARNESS AND CONNECTOR (REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY LH - MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)) |
Disconnect the I13 main body ECU (multiplex network body ECU) connector.
Disconnect the N15 rear door courtesy light switch assembly LH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| N15-1 - I13-1 (LCTY) | Always | Below 1 Ω |
| N15-1 - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||
| 4.CHECK HARNESS AND CONNECTOR (REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY RH - MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)) |
Disconnect the I13 main body ECU (multiplex network body ECU) connector.
Disconnect the O16 rear door courtesy light switch assembly RH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| O16-1 - I13-6 (RCTY) | Always | Below 1 Ω |
| O16-1 - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||