DTC P0500 Vehicle Speed Sensor "A" |

| DTC No. | DTC Detection Condition | Trouble Area |
| P0500 | While vehicle being driven, no vehicle speed sensor signal transmitted to ECM (1 trip detection logic). |
|
| Required Sensors/Components (Main) | Vehicle speed sensor Combination meter assembly Skid control ECU |
| Required Sensors/Components (Related) | Park/Neutral position switch assembly Engine coolant temperature sensor Crankshaft position sensor Throttle position sensor Mass air flow meter sub-assembly |
| Frequency of Operation | Continuous |
| Transaxle counter gear revolution | 300 rpm or higher |
| Vehicle speed sensor signal | No signal |

| Tester Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|

| 1.READ VALUE USING INTELLIGENT TESTER (VEHICLE SPEED) |
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG) and turn the tester on.
Enter the following menus: Powertrain / Engine / Data List / All Data / Vehicle Speed.
Drive the vehicle.
Read the value displayed on the tester.
| Result | Proceed to |
| Values displayed on tester and speedometer display not equal | A |
| Values displayed on tester and speedometer display equal | B |
|
| ||||
| A | |
| 2.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - ECM) |
Disconnect the combination meter assembly connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I18-3 (+S) - A25-10 (SPD) | Always | Below 1 Ω |
|
| ||||
| OK | |
| 3.CHECK COMBINATION METER SYSTEM |
Check the circuits that send vehicle speed signals to this system in the combination meter system (Click here).
| NEXT | |
| 4.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED |
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the tester on.
Clear the DTCs (Click here).
Turn the engine switch off and wait for at least 30 seconds.
Start the engine.
Turn the tester on.
Drive the vehicle in accordance with the driving pattern described in Confirmation Driving Pattern.
Enter the following menus: Powertrain / Engine / DTC.
| NEXT | ||
| ||