SEAT BELT WARNING SYSTEM (w/o Occupant Classification System) > Driver Side Seat Belt Warning Light does not Operate |

| 1.READ VALUE USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Main Body / Data List.
Read the Data List according to the display on the intelligent tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| D Seat Buckle SW | Driver seat belt buckle switch/ON or OFF | ON: Driver seat belt unfastened OFF: Driver seat belt fastened | - |
|
| ||||
| OK | |
| 2.PERFORM ACTIVE TEST USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Combination Meter /Active Test.
Perform the Active Test according to the display on the intelligent tester.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Driver Side Seat Belt | Seat belt warning light | OFF/ON | - |
|
| ||||
| OK | ||
| ||
| 3.INSPECT FRONT SEAT INNER BELT ASSEMBLY (FOR DRIVER) |
![]() |
Remove the front seat inner belt assembly (for driver) (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 2 - 3 | Driver seat belt unfastened | Below 1 Ω |
| 2 - 3 | Driver seat belt fastened | 10 kΩ or higher |
| *a | Component without harness connected (Front Seat Inner Belt Assembly (for Driver)) |
|
| ||||
| OK | |
| 4.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY |
Remove the main body ECU (multiplex network body ECU) (Click here).

| *A | for LHD | *B | for RHD |
| *a | Component without harness connected (Instrument Panel Junction Block Assembly) | - | - |
Disconnect the 3C instrument panel junction block assembly. (for LHD)
Disconnect the 3A instrument panel junction block assembly. (for RHD)
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| MB-18 (DBKL) - 3C-35 | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| MB-18 (DBKL) - 3A-38 | Always | Below 1 Ω |
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - FRONT SEAT INNER BELT ASSEMBLY - BODY GROUND) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3C-35 - N2-3 | Always | Below 1 Ω |
| N2-3 - Body ground | Always | 10 kΩ or higher |
| N2-2 - Body ground | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| 3A-38 - O3-3 | Always | Below 1 Ω |
| O3-3 - Body ground | Always | 10 kΩ or higher |
| O3-2 - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||