Home › Suspension › TIRE / WHEEL › TIRE AND WHEEL SYSTEM (for TMC, TMMR Made)

TIRE AND WHEEL SYSTEM (for TMC, TMMR Made) > INSPECTION

for Preparation Click here



1. INSPECT TIRES
  1. Check the tires for wear and proper inflation pressure.

    Cold Tire Inflation Pressure:

    Tire Size
    4 passengers or less
    5 passengers
    Front
    kPa (kgf/cm2, psi)
    Rear
    kPa (kgf/cm2, psi)
    Front
    kPa (kgf/cm2, psi)
    Rear
    kPa (kgf/cm2, psi)
    215/60R16 95V
    230 (2.3, 33)
    230 (2.3, 33)*1
    240 (2.4, 35)*2
    270 (2.7, 39)*3
    215/55R17 93V
    230 (2.3, 33)*1, *2
    240 (2.4, 35)*3
    230 (2.3, 33)
    230 (2.3, 33)*1
    260 (2.6, 38)*2
    290 (2.9, 42)*3

    *1: For driving under 160 km/h (100 mph)
    *2: For driving at 160 km/h (100 mph) to 180 km/h (112 mph)
    *3: For driving at 180 km/h (112 mph) to 210 km/h (131 mph)



    C137874
  1. Using a dial indicator, check the runout of the tires.

    Maximum Tire Runout:
    1.4 mm (0.0551 in.)



2. ROTATE TIRES


    C163157
  1. Rotate the tires as shown in the illustration.
    Text in Illustration 
    V100135
    Front



3. INSPECT AND ADJUST WHEEL BALANCE


  1. Inspect and adjust the off-the-car balance.

    1. Steel wheel:

      Maximum Wheel Imbalance:
      8.0 g (0.0176 lb)



    2. C144018E10
    3. Others (Non-steel wheel):
      Text in Illustration 
      *a
      25 mm (0.984 in.)

      Maximum Wheel Imbalance:
      8.0 g (0.0176 lb)

      NOTICE:
      1. Use a cleaning detergent to remove dirt, oil and water from the surface where the balance weight is to be adhered.
      2. Do not touch the adhesive surface of the tape.
      3. Adhere a sticking type balance weight to the flat surface*a shown in the illustration.
      4. Push the balance weight securely with your finger to adhere it to the desired position.
      5. Do not reuse balance weights.

      HINT:
      The inner side balance weight should be installed by clipping it to the rim.



4. INSPECT FRONT AXLE HUB BEARING
(Click here)


5. INSPECT REAR AXLE HUB BEARING
(Click here)